Need help?Do you have a question about the CYBELEC CybTouch 15PS and is the answer not in the manual?
Users must read, understand, and respect directives in the manual for safe operation.
Sign indicates rules, instructions, or advice, symbolizing personnel danger.
Touchscreens are pressure sensitive; press gently to avoid damage.
Parameter to choose the display options on the Bend Numerical Page.
Displays a manual button for direct access to Manual Axes Movement.
Applies a permanent correction to the Bottom Dead Centre position.
Calibrates the touchscreen to ensure correct operation.
Controls recalculation of axes positions when a part is loaded.
Allows manual movement of axes for setup or tooling changes.
Manually adjusts back gauge (X, R) and beam (Y1, Y2) positions.
Displays hardware status and allows performing maintenance actions.
Transfers data between CybTouch and a USB key.
Explanation of the Bend Numerical Page as the primary working and navigation interface.
Manages Y axis with three modes: angle, calculated target, bottoming.
Manages X axis with two modes: flange length entry and targeted position.
Activates crowning function, allowing manual or automatic adjustment.
Allows creation and configuration of punches for bend calculations.
Intuitive profile drawing directly on the screen for part creation.
Repeats sequence indefinitely for applying corrections bend by bend.
Corrects the measured angle on this page, not directly in program step.
Allows manual or automatic adjustment of the crowning value.
Applies correction to back-gauge X and R axis positions.
Allows running two or several part-programs sequentially.
Step-by-step guide to converting part-programs from PC-ModEva.
Step-by-step instructions for making a bend using the EasyBend page.
Messages displayed on green background; informational or instructional.
Users must read, understand, and respect directives in the manual for safe operation.
Sign indicates rules, instructions, or advice, symbolizing personnel danger.
Touchscreens are pressure sensitive; press gently to avoid damage.
Parameter to choose the display options on the Bend Numerical Page.
Displays a manual button for direct access to Manual Axes Movement.
Applies a permanent correction to the Bottom Dead Centre position.
Calibrates the touchscreen to ensure correct operation.
Controls recalculation of axes positions when a part is loaded.
Allows manual movement of axes for setup or tooling changes.
Manually adjusts back gauge (X, R) and beam (Y1, Y2) positions.
Displays hardware status and allows performing maintenance actions.
Transfers data between CybTouch and a USB key.
Explanation of the Bend Numerical Page as the primary working and navigation interface.
Manages Y axis with three modes: angle, calculated target, bottoming.
Manages X axis with two modes: flange length entry and targeted position.
Activates crowning function, allowing manual or automatic adjustment.
Allows creation and configuration of punches for bend calculations.
Intuitive profile drawing directly on the screen for part creation.
Repeats sequence indefinitely for applying corrections bend by bend.
Corrects the measured angle on this page, not directly in program step.
Allows manual or automatic adjustment of the crowning value.
Applies correction to back-gauge X and R axis positions.
Allows running two or several part-programs sequentially.
Step-by-step guide to converting part-programs from PC-ModEva.
Step-by-step instructions for making a bend using the EasyBend page.
Messages displayed on green background; informational or instructional.
General| Brand | CYBELEC |
|---|---|
| Model | CybTouch 15PS |
| Category | Control Systems |
| Language | English |
To Next Page
