(Menu Button) → Other menus → Service → Service
Allows the operator to manually adjust the position of the back gauge (axes X and R) and
the beam (axes Y1 and Y2).
A level 2 password is required to use this function. It must be used with utter care and
only by experienced personnel. Wrong settings may mechanically damage the machine.
Settings are lost after indexing the machine.
The Maintenance page displays the hardware status of the CybTouch and lets the operator
perform different maintenance actions.
(Menu Button) → Other menus → Service → Service → Maintenance
All the following actions require codes and should only be performed by technicians
or upon request of a technician.
To Next Page
Loading...
