connector from the battery. Place the battery into the right side of the compartment. Note: Only new batteries should be used for replacement and both
batteries should be replaced at the same time to ensure maximum life span.
11. Close the battery compartment cover and tighten the retaining screws.
12. Recharge the UPS for 8-16 hours to fully charge the battery.
DEFINITIONS FOR ILLUMINATED LED INDICATORS
On-Line
On Battery
AVR
Overload
Alam
Condition
On Off Off Off Off Normal
Off
Flashes while
beeping
Off Off
Beep twice every 30
seconds
Utility Failure – The UPS is providing power to battery-protected
outlets from its battery.
Off
Flashes while
beeping
Off Off
Rapid beeping EV
second 1/2 s e
Utility Failure – The UPS is providing battery power. Rapid
beeping indicates the unit will run out of power shortly.
0- Of Off/On Off On Constant tone
Overload Fault – Occurs when connected equipment exceeds the
listed capacity of the UPS. Turn the UPS off. unplug at least one
piece of equipment from battery outlets. wait 10 seconds. reset the
circuit breaker and turn the unit on.
On/Off Off/On Off Off Constant tone
Short Fault – Unplug at least one piece of equipment from battery
outlets and turn the UPS on again.
UPS Fault – Contact CyberPower Systems for support.
On/Off Off/On Off Off Beep every 2 seconds Charger Fault – Contact CyberPower Systems for support.
FUNCTION SETUP GUIDE – SENSITIVITY SETUP
Even when the UPS is operating normally (online mode), the AC input voltage may not be stable all the time. Sensitive equipment may be prone to damage
caused by unexpected voltage fluctuations. Use the following steps to adjust the sensitivity of the UPS unit:
1. Please make sure the UPS is in LINEMODE and operating in a normal condition.
2. To Enter the Sensitivity Setup mode, press the MUTE Button for 6 seconds until all indicators flash rapidly.
3. The unit will show the current sensitivity setting, as shown in the following table.
4. To select the Low Sensitivity setting: shortly press the MUTE button until one red indicator flashes.
5. To select the Medium Sensitivity setting, shortly press the MUTE button until red and yellow indicators flash.
6. To select High Sensitivity setting, shortly press the MUTE button until green, yellow and red indicators flash.
7. To set up a level of sensitivity, hold down the MUTE button until the green indicator (the first one) illuminates.
8. Once in setup mode, if there is no action within 7 seconds, the unit will exit setup mode without changing any settings.
Indicators
Illuminate
Sensitivity Description
1 (Red) Low
If the connected equipment can tolerate more power events (for example: unstable power often associated with stormy
weather), select Low Sensitivity, and the UPS will go to Battery Mode less often.
2 (Yellow, Red) Medium (Default) The UPS will go to Battery Mode if the power is unstable.
3 (Green, Yellow,
Red)
High
If the connected equipment is more sensitive to power events, select High Sensitivity, and the UPS will go to Battery
Mode more often.
TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
