TROUBLESHOOTING -continued
Problem Possible Cause Solution
PowerPanel® is inactive
(all icons are gray).
The unit is not providing battery
power.
Shutdown your computer and turn
the UPS o. ait 10 seconds and
turn the UPS back on. his should
reset the unit.
The serial cable is not the cable
that came with the unit.
Please use the serial cable
that came with the unit for
the software.
The USB power ports are
not providing power to the
connected devices.
The USB power port has Over
Current Protection design. When
the total current of connected
devices is over 3.1A, the USB
power ports will stop providing
power to the connected devices.
Turn the UPS o and unplug
at least one piece of device
connected to the USB power
port and then turn the UPS on.
W
T
Additional troubleshooting information can be found at “Support” at www.CyberPowerSystems.com
Model CST1500S
Capacity 1500VA / 900W
Nominal Input Voltage 120 Volts
Input Frequency 60 Hz +/- 3 Hz
On-Battery Output Voltage 120 VAC +/- 5%
Max. Load for UPS Outlets
(5 Outlets)
1500 VA / 900 W
Max. Load for Full-Time
Surge Protection Outlets
12 Amps
On-Battery Output Wave Form Adaptive Sinewave
Operating Temperature + 32°F to 104° F / 0°C to 40°C
Operating Relative Humidity 0 to 95% non-condensing
Size (W x H x D) 14.2 in., 3.9 in., 10.4 in. (361 mm, 99mm, 264 mm)
Net Weight 24.7 lbs / 11.2 kg
Battery Type CyberPower / RB1280X2B
Typical Battery Recharge Time 8 hours from total discharge under 100% load
Typical Battery Life 3 to 6 years, depending on number of discharge/recharge cycles
Recommended Battery Sealed Maintenance Free Lead Acid Battery
Safety Approvals UL1778, CSA C22.2 No 107.3, FCC/DoC Class B
TECHNICAL SPECIFICATIONS
To Next Page
Loading...
Need help?
General
