32
Installing and Removing the Infant Car Seat
Installing with Base Using LATCH/UAS
7. Pull the LATCH/UAS Adjustment Strap while
pushing Base tight against the seat.
Remove all slack from the strap, being careful
not to overtighten, then lay the free end across
the Belt Path. The SafeLock Belt Tensioner will
tighten the system fully.
8. Press down on the sides of the SafeLock Belt
Tensioner until an audible CLICK is heard
and the Belt Lock Indicator turns GREEN. If
Belt Tensioner does not lock, try loosening the
LATCH/UAS Strap slightly, then try to close
again.
9. Grab the Base at the Belt Path and pull from
side to side and front to back to make sure it is
installed correctly. The Base should not move
more than 2.5 cm (1 in) in any direction.
If the Base moves too much, open the SafeLock
Belt Tensioner and remove a little more slack
from the LATCH/UAS Strap, then close and
recheck. After this, if the Base still moves too
much, you may need to try a different vehicle
seat location or installation method, or both.
ii
oo
To Next Page
Loading...
