26
20
25
44
REMOVING THE COVER
!
WARNING! The cover is an integral component of the car
seat's safety design. The car seat must therefore never be
used without the cover.
Removal
The cover consists of 6 components fixed to the seat shell
by elastic piping, snap buttons and brackets. Once you have
released all the fastenings, you can remove the individual
components for washing.
Proceed as follows:
• Open the belt buckle (20) of the 5-point belt system.
• Open all snap buttons of the pads and cover parts
(25)
.
• Unhook the shoulder pads from the brackets
(26)
.
• Remove all belt pads.
• Thread the shoulder belts out of the cover.
• Remove the cover by pulling it forwards.
• To fix the cover again on the seat carry out the steps in
reverse order.
NOTE! Before detaching the cover please pull out the elastics
under decorative parts to avoid damage.
NOTE! When remounting the shoulder pads, it is essential to
ensure that ...
• the closed
side faces towards the childs neck.
• the shoulder pads are perfectly mounted on the brackets (26).
• the shoulder belts are guided inside the shoulder pads
To Next Page
Loading...
