14
y
x
a
w
v
car seat. In order to guarantee maximum protection for the child, the seat must
be in a normal, upright position.
!
Carry out the installation steps in reverse order.
NOTE
NOTE! Retracting the connectors not only protects the car seat, but also protects
PLACING THE CHILD SEAT IN THE CAR
RELEASING THE ISOFIX CONNECTORS
Release the ISOFIX connectors (w) on both sides, by pressing and
pulling back the red release buttons (y).
Pull the seat out of the ISOFIX guides (u).
Turn the ISOFIX connectors (w) 180°.
Activate the handle (v) on the underside of the child seat and push the connectors
in until they reach the end position.
Place the child seat on the appropriate seat in the car.
To install the seat in an upright position for the child it is essential to take care
that the backrest (a) of the child seat lies flush against backrest of the car seat. To
achieve this, push the seat toward the car seat backrest.
By using the ISOFIX anchorage points (i) in the car, you can adjust this
distance with the handle (v) on the underside of the child seat.
If the headrests of the car seats get in the way, pull these completely
out, turn them round, or detach them completely (exception see section „THE
BEST POSITION IN THE CAR“). The backrest (a) adjusts itself in one movement
to almost every position of the car seat.
To Next Page
Loading...
Need help?
General
