20
Warning! Never use chemical cleaning or bleaching agents!
!
To guarantee that your child seat provides the maximum protection, it is essential to
comply with the following points:
The cover consists of three main components for headrest, backrest and seat
cushion, which are secured to the child seat either by velcro, press-studs or elastic
bands. Once you have released all the fastenings, you can remove the individual
components for washing. To detach the individual components of the cover carry
out the following steps:
To replace the cover, carry out the same steps in the reverse order.
Care must be taken that only an Original CYBEX Seat Cover is used, because the
cover is also a fundamental component of the good functioning of the child seat.
Replacement covers may be obtained from a specialist shop.
NOTE
PRODUCT CARE
CLEANING
REMOVING THE SEAT COVER
All visible parts of the child seat must be regularly checked for damage. The
mechanical parts must function faultlessly.
It is essential to make sure that the child seat is not jammed between hard parts
such as the car door, seat rails etc., which can damage it.
If the child seat is dropped it must be tested by the manufacturer before being
used again.
Once the press-studs on the back of the backrest have been undone, the cover
can be removed by drawing it forwards.
To remove the seat cushion cover, release both belt straps and also undo the
press-studs on the underside and draw the cover forward.
The headrest cover can simply be pulled forward to remove it.
To Next Page
Loading...
Need help?
General
