CycleOps Joule 2.0 - Page 61

Joule 2.0 User Guide page 61
Chapter 7: Setting Up CycleOps Joule 2.0
Setting Up Memory
Joule 2.0 has 4 MB of onboard memory for storing activities, history and workouts. See Chapter 1:
Data Management for details.
1. Press and release the [MODE] button until Main mode is displayed.
2. Press [JOYSTICK] up/down to highlight Setup Joule. Press [JOYSTICK] in and
release to select Setup Joule.
3. Press [JOYSTICK] up/down to highlight Memory. Press [JOYSTICK] in and
release to select Memory.
4. Press [JOYSTICK] up/down to highlight Record Control. Press [JOYSTICK] in
and release to select Record Control.
5. Press [JOYSTICK] up/down to switch between Speed and HRM.
Press [JOYSTICK] in and release to save changes.
6. Press [JOYSTICK] up/down to highlight End Ride Time.(min) Press [JOY-
STICK] in and release to select End Ride Time (min) from 15, 30, 60, 90 or never.
Press [JOYSTICK] in and release to save changes. After ride has ended, it has
been entered into History data. Note: End ride time controls when the current
ride automatically is saved to History and Reports.
7. Press [JOYSTICK] up/down to highlight Odometer. Press [JOYSTICK] in and
release to select Odometer. Press [JOYSTICK] up/down/left/right to adjust
Odometer. Press [JOYSTICK] in and release to save changes. Press [JOYSTICK]
up/down hightlight Reset Odometer. Press [JOYSTICK] in and release to reset
odometer to defaults.
8. Press [JOYSTICK] up/down to highlight Clear Ride Memory. Press [JOYSTICK]
in and release to select Clear Ride Memory.
>
Speed
End Ride Time (min):
90
>
Power Avg (sec):
>
1
>
Power Zeros:
>
Cadence Avg (sec):
>
>
1
Units:
>
English
>
Pair New Sensor
>
Back
<
Report
Main
Memory
30
Clear Ride Memory
>
Odometer (Miles):
0000798
Reset Odometer
Record Control: