PIN OVER-RIDE PROCEDURE
To illustrate the PIN over-ride procedure we
will assume a PIN of 4,3,2,1.
1. Turn the lock on the back of the siren to
disable the sound.
2. If indicators are still flashing, allow the
system to reset with all doors closed.
3. Turn ignition switch to ON position, the
status LED will remain lit.
4. Turn ignition switch to the ACC position and
count the LED flashes.
5. Turn ignition switch ON when the 4th flash has extinguished.
6. Turn back to ACC position and count 3 flashes, switch ignition ON.
7. Turn back to ACC position and count 2 flashes, switch ignition ON.
8. Turn back to ACC position and count 1 flash, switch ignition ON.
When all four digits have been entered correctly, the car’s indicators will
flash once to confirm that the immobiliser is disarmed. The engine can be
started and the car driven. The automatic arming feature will ensure car is
secured again if the ignition is left off for more than 40 seconds.
SIREN
DUST CAP
LOCK
KEY
SWITCH SIREN OFF
-10-
To Next Page
Loading...