CHANGING PIN CODE
To alter the PIN code of the system, follow the standard option change
procedure; select option #19.
! The vehicle indicators will flash twice to inform you that the system is
ready to accept the new PIN. The “time-out” is set to two seconds. If
the programming has not begun before then, the system will drop-out
of programming mode.
! Enter the new digits by momentarily pressing the main button on a
valid remote control. The vehicle indicators will flash in response to
each press. Stop pressing when the correct digit count is achieved.
Each digit will be confirmed by two indicator flashes.
! Enter the remaining digits in the same fashion. Four flashes will
confirm the programming procedure is complete.
Arm the system and confirm the new PIN by completing override
procedure (page 10). Ensure the new PIN is recorded, but do not leave in
vehicle.
-14-
To Next Page
Loading...