PROGRAMMABLE OPTION DESCRIPTIONS cont’
!
standard indicator flashes will accompany each arm/disarm command, but
the siren will remain silent.
! Option #15** enables the auto-relock feature. The doors will
automatically re-lock when the vehicle has been disarmed by remote
control and the doors remain closed for more than 120 seconds.
! Option #17** is used to extend the time length of the central locking
pulses. Vehicles that use a pneumatic central locking system require
about three seconds to allow the pump to charge the air hoses. Enable this
option only to extend the time in these situations.
Warning: extending the pulse time to a direct drive relay will cause damage to actuator.
! Option #19 is used to change the values of the Emergency PIN. A card
with the PIN details must be supplied by your installer. Please contact
your installer if the card is missing.
! Option #21 the alarm system can be set to produce an open door warning
when arming. The warning is in the form of a short series of chirps from
the siren or horn. Do not enable this option where the dome light
illumination is extended by the vehicle’s timing circuit.
** optional feature - will require additional connection(s).
Option #13** sets the system to always arm/disarm in silent mode. The
-13-
To Next Page
Loading...