3- There is a wire leading to the speed controller which must be
plugged in at the bottom of the battery for it to function.
Make sure the wire is firmly fastened to the battery. Never
plug or unplug the battery without switching it off first
(failure to do so will risk a short circuit).
4- The battery can be charged either on or off the bike
through the charger input.(system has to be off)
LCD Dashboard (This applies only to models with an LCD
handlebar dashboard)
1- The LCD has an on/off switch.
This must be switched on for
the bike to receive power.
2- If you have a throttle
connected but you are not
using it the bike will provide
you with assistance via the pas
while you are pedalling if the
pas level is higher than 0.
3- You can use the UP/DOWN
buttons to increase/decrease the amount of
assistance you would like the bike to provide.(via pas)
4- Switching the power off will transform your bike into a
normal push bike.
5- The LCD also provides other functions such as speed, time,
distance of your journey etc (see LCD instructions). Please
note that the battery function on the LCD may not
10
Copyright December 1st Cyclotricity Ltd
To Next Page
Loading...