Part 1 – Before first time use
The bike has been 95% readily assembled for you. To save space in the
carton, it was packed with the pedals detached and the handlebar
turned 90 degrees. If you are not familiar with how to perform these
fittings, we strongly recommend you seek assistance of a professional
bike service shop as damages caused by wrong assembly is NOT
covered by your warranty. A bike service shop will also adjust your
brakes and gears for you for best performance as they start to require
this after lots of use.
On the other hand, if you choose to perform these tasks by
yourself, you will need the following tools:
1- 5mm hex key
2- 10mm wrench
3- Screw driver
4- Pump
5- 15mm spanner
Although your Cyclotricity bike has been thoroughly tested, it is
important that you perform some basic checks before first time use.
You are also recommended to perform these checks regularly in the
future to protect yourself and your Cyclotricity bike:
1- Check brakes and brake isolators are functioning properly.
2- Check all other nuts, bolts and fixings are properly
tightened, pay particular attention
to the motor fixings. You will notice
that there is an unusual washer
(image left) with a small axle
around the motor spindle (called
torque washer). Make sure that
the axle of the washer slides
inside the dropout to hold it still.
3
Copyright December 1st Cyclotricity Ltd
To Next Page
Loading...