charging for 12 hours for the first 3 charges to
condition your battery.
2- Always connect the charger to the battery before
connecting it to the mains. This is to avoid static
sparks.
3- Always disconnect the charger from the mains before
disconnecting the charger from the battery.
4- The battery must be switched on while charging (however,
only switch it on after the charger has been securely
plugged in to avoid risk of short circuits).(This is also not
compulsory that it is on while charging)
5- Do not leave the charger connected to the mains when
not in use.(this due to the risk of static current sparks)
Water
Your electric bicycle is rain and splash resistant and can be used
in all weathers. The electrical components of the vehicle, such as
motor, battery, and controller, must not be submerged in water.
Maintenance
WARNING: Do not attempt to open the casings of the battery or
motor as it could be dangerous and all warranties will become void.
If you experience problems, refer to the troubleshooting guide in
this manual or ask your local dealer.
1- The brake levers should be in enough contact with the
discs to lock the rear wheel without pulling all the way to
the bars and come to a stop in a fairly short time. If not
please adjust following the instructions in this manual or
seek assistance of a local bike service shop.(The brakes
power will be determined by a multitude of facts, for
example rider weight and terrand and conditions)
To Next Page
Loading...