Push aided mode
- It is possible to use the 6km/h assistance mode while
walking your bike. To do so, press and hold the DOWN
button, the push aided indicator will start flashing. The
bike will run at no more than 6km/h as you walk the
bike along.
- Release the DOWN button to suspend this function.
Trip Data View
- To enter the history trip data view, press the SW button
once while the device is on. The ODO and TTM will appear.
- Press the UP/DOWN buttons to access the maximum
speed and average speed information.
- Press SW again to exit this view (or it will
automatically exit this view after 5 minutes of riding).
User Setup
You will need to configure the following functions on your device:
a. Maximum speed.
b. Wheel diameter (16”-28”).
c. Unit selection (Miles or Km, MPH or Km/h).
Setup
- Press and hold the SW button to switch the device on.
- Press and hold both the UP and DOWN buttons at the
same time for 3 seconds. This will take you into the LCD
setup view.
13
Copyright December 1st Cyclotricity Ltd
To Next Page
Loading...