You are advised to regularly maintain, clean and check the status of the
bike and motor system as dirt will accumulate throughout the rides and
additional strain will be taken by the drivetrain due to the powerful motor
system. We recommend that users should inspect the bike and motor
condition before and after each ride.
Disconnect all power supplies from the drive unit before starting any
work (e.g., inspection, repair of the bike, maintenance work etc,) on the
bike, transportation or storage. Unintentional activation of the drive
could lead to serious damage or injury.
Never reach into the chains, gears or any moving parts while the bike is
still in operation.
As the drive unit can get hot after use, be sure to give it some time to cool
down before performing any maintenance.
Store the bike in a cool and dry place, sheltered from direct sunlight and
potential rain.
Do not attempt to disassemble or modify the drive unit. The drive unit
may only be repaired and maintained by qualied experts and only
replaced with original spare parts. This will ensure that the safety/
warranty of the drive unit is maintained.
The active moving parts (e.g., chain, gear, speed reducer etc.) should be
regularly lubricated to maintain desired performance. In case of any
abnormal activity, stop using the drive unit immediately and contact your
CYC dealer.
General Maintenance
Do not attempt to replace the product parts with the parts that have
been found at a local bicycle store as the materials used in the drive unit
are specically designed for their purposes.
All bolts, nuts and screws are required to be tightened to the correct
torque, if there is anything loose, stay o the bike. Torque specications
for each bolt and nut is provided.
44
05
MAINTENANCE
To Next Page
Loading...