CYP PUV-1210PL-RX - Page 17

17
number of ports on that specic interface.
<Command> {Port1}+{Port2}+{Etc.} {Parameter [= Value]}
Examples: ZoneLineOut A+B+C Treble = -12
HDBT_Out A+D+F Mute
Multi-Slot Command Format (ZoneAvPair)
The ZoneAvPair command allows for multiple slots on a single HDBaseT
or HDMI output to be assigned the same value simultaneously. Use the
following syntax to accomplish this. Note that each additional slot uses
the “+” character for separation. The number of slots allowed in a single
command is limited by the number of slots on that specic interface.
ZoneAvPair HDBT_Out {Port} Slot {Slot1}+{Slot2}+{Etc.} {Param [=
Value]}
Example: ZoneAvPair HDBT_Out B Slot 1+3+5 VideoSrc = HDMI_In 2
Multi-Parameter Command Format
Use the following syntax to set or change multiple parameters for a
single port. Note that each additional parameter uses the “,” character for
separation and spaces are allowed. The number of parameters allowed in
a single command is limited only by the number of individual parameters
that command has.
<Command> {Port} {Param1 [= Value]}, {Param2 [= Value]}, {Etc.}
Examples: ZoneLineOut C Treble = -12, Mute, Delay = 100
HDBT_Out A VideoSrc = HDMI_In 1, AudioSrc = HDMI_In 1
Multi-Parameter Command Format (ZoneAvPair)
The “VideoSrc”, “AudioSrc” and “Load” parameters may be combined on a
ZoneAvPair command. Note that the “,” character is used for separation.
ZoneAvPair HDBT_Out {Port} Slot {Slot} {Param1=Value},
{Param2=Value}
Example:
ZoneAvPair HDBT_Out B Slot 5 VideoSrc=HDMI_In 2, AudioSrc=CoaxIn 1