CYP PUV-1210PL-RX - Page 18

18
Complex Multi-Port/Parameter Command Format
It is possible to have a single command that aects multiple ports with
multiple groupings of parameters. All previously explained syntax rules
must be observed and each additional set of ports/parameters are
separated by the “&” character.
<Command> {Port1}+{Port2}+{Etc.} {Param1 [= Value]}, {Param2 [=
Value]}, {Etc.} & {Port1}+{Port2}+{Etc.} {Param1 [= Value]}, {Param2 [=
Value]}, {Etc.} & Etc.
Example:
HDBT_Out A+C+E VideoSrc=HDMI_In 2, AudioSrc=CoaxIn 1 & B+D Mute & F
VideoSrc=HDMI_In 1, AudioSrc=HDMI_In 1
Complex Multi-Slot/Parameter Command Format (ZoneAvPair)
The ZoneAvPair command can also control multiple slots with multiple
parameter groupings however the syntax is slightly dierent. Each
command can only aect a single port at a time. Each additional set of
slots/parameters are separated by the “&” character.
ZoneAvPair HDBT_Out {Port} Slot {Slot1}+{Slot2}+{Etc.}
{Param1=Value}, {Param2=Value} & Slot {Slot1}+{Slot2}+{Etc.}
{Param1=Value}, {Param2=Value} & Etc.
Example:
ZoneAvPair HDBT_Out B Slot 1 VideoSrc=HDMI_In 2, AudioSrc=CoaxIn
1 & Slot 2+3+4 VideoSrc=HDMI_In 2, AudioSrc=AnalogIn 1 & Slot 5+6
VideoSrc=HDMI_In 1, AudioSrc=HDMI_In 1 & Slot 1 Load
6.8.2 Real World Command Use
Zone A/V Pairing Mode Command Example
The easiest way to use the matrix for simple HDMI switching while still
allowing for individually tailored zone audio is to use the Zone A/V Pairing
setting within the WebGUI.
This is a congured and saved setting allowing each HDMI input to be
paired with dierent audio inputs, depending on the zone it is being
output to, for easy selection from a remote within that zone. For example,
certain zones might not be able to handle surround sound, so you can
pair the video in that zone with stereo inputs. Please review to section
6.10.6 for details of Zone A/V Pairing conguration.