19
COMMAND DESCRIPTION
ZoneAvPair HDBT_Out A Slot 1 Load Load the 1st A/V pairing for
HDBaseT Output A’s zone
Optical Audio Return (OAR) Command Example
If you are also using the Zone Audio outputs (Stereo Zones) for any zone
we recommend using the Optical Audio Return (OAR) function to set the
Zone Audio output to always play the audio coming from the TV itself.
In this way the end user can freely switch between the matrix input on
the TV and the internal tuner/smart functions of the TV and always be
guaranteed audio (remember to set the TV’s optical output to LPCM 2.0).
This command only needs to be resent after an audio only source has
been selected for that individual Zone Audio output. Commonly a control
system would have a “TV” button in the audio source selection area along
with your other audio sources.
COMMAND DESCRIPTION
ZoneLineOut A AudioSrc=OAR_In A Zone Audio output “A” plays OAR
audio from the TV connected to
HDBaseT output “A”
HDMI Mirroring Command Example
If you have rack (head end) based AVR’s for surround sound rooms we
recommend using the HDMI outputs and the HDMI mirroring mode to
easily have the audio and video sent to the AVR follow the signal sent to
that zone’s TV.
As long as no further commands are ever sent to the HDMI outputs of the
matrix you only need to set this up once:
COMMAND DESCRIPTION
HDMI_Out H Mirroring=HDBT_Out A Set HDMI output “H” to mirror
HDBaseT output “A”
When using the mirroring function you can use any standard commands
with the mirrored HDBaseT output and the mirroring HDMI output
will follow the commands. These can be an A/V Pairing, Video or Audio
commands, etc.
To Next Page
Loading...