CYP PUV-1210PL-RX - Page 20

20
Audio Only source selection Command Examples
This unit oers 4 direct audio only inputs, while some of these inputs will
likely be used for down mixed audio signals from surround sound sources
(for stereo only zones) we expect audio only sources to be connected to
deliver just audio to both TV zones and Audio Only zones.
COMMAND DESCRIPTION
ZoneLineOut A AudioSrc=AnalogIn 1 Route Analogue input 1 to Zone
Audio output “A”
ZoneLineOut A AudioSrc=OpticIn 1 Route Optical input 1 to Zone
Audio output “A”
ZoneLineOut A AudioSrc=CoaxIn 1 Route Coaxial input 1 to Zone
Audio output “A”
ExtLineOut 1 AudioSrc=AnalogIn 1 Route Analogue input 1 to
Extended Line output “1”
ExtLineOut 1 AudioSrc=OpticIn 1 Route Optical input 1 to Extended
Line output “1”
ExtLineOut 1 AudioSrc=CoaxIn 1 Route Coaxial input 1 to Extended
Line output “1”
Above are just a few example of the audio selections available. Please
refer to the full command listing for all possible commands. Remember if
you have congured any audio zones to play the OAR audio from the TV
within a zone you must be able to select this again to return to “listening”
to that TV.
Individual Audio and Video Routing Command Examples
To oer the greatest level of exibility the matrix can be used to send
individual commands for both video and audio, this allows the installer
to completely tailor the matrix to suit any possible conguration the end
user may require.
Route audio and video from HDMI input 1 to HDBaseT output A
independently:
COMMAND DESCRIPTION
HDBT_Out A VideoSrc=HDMI_In 1 Video switch command
HDBT_Out A AudioSrc=HDMI_In 1 Audio switch command