CYP PUV-1210PL-RX - Page 29

29
COMMAND DESCRIPTION
IPCONFIG Display the current IP
conguration.
P0 Enter light stand-by mode. (RS-232,
Ethernet and PoH functionality is
still active.)
P1 Turn the power on.
P2 Enter deep stand-by mode. (Only
RS-232 functionality is still active.)
P? Report the current power status.
PRESET Save M Save the current A/V routing as a
preset.
M = 1~8
PRESET Load M Load and activate a saved A/V
preset.
M = 1~8
PRESET Show [M] List the contents of a stored A/V
preset.
M = 1~8 (If M is omitted, list all A/V
presets.)
PRESET name M={NameString} Set the verbose name of a preset.
Maximum 32 characters.
M = 1~8