CYP PUV-1210PL-RX - Page 33

33
COMMAND DESCRIPTION
ZoneAvPair HDMI_Out M Slot N VideoSrc=XXX Assign a video source to a Zone A/
V Pair slot on an HDMI output.
M = G~H
N = 1~11
Available XXX values:
HDMI_In n [n=1~6]
Pattern
Note: HDMI_In is not available for
use with slot 11.
ZoneAvPair HDMI_Out M Slot N Load Load and activate the contents of
a Zone A/V Pair slot on an HDMI
output.
M = G~H
N = 1~11
IR_Route HDBT_Out M0 M1 M2 Select the IR source(s) for an
HDBaseT output.
M0 is the output port index.
M1 is the function to use.
M2 is the IR input source.
M0 = A~F (supports multiple port
selection by using “+”.)
Available M1 values:
Add [Add M2 source to M0]
Del [Remove M2 source from M0]
Available M2 values:
IR_InAll [IR In (ALL) input jack]
Generator [Internal IR encoder]