34
COMMAND DESCRIPTION
IR_Route HDBT_Out M0 Show Display the current IR source of the
HDBaseT output.
M0 = A~F (supports multiple port
selection by using “+”.)
IR_Route IR_Out M0 M1 M2 Select the IR source(s) for an IR
Output jack (next to each HDMI
input).
M0 is the output port index.
M1 is the function to use.
M2 is the IR input source.
M0 = 1~6 (supports multiple port
selection by using “+”.)
Available M1 values:
Add [Add M2 source to M0]
Del [Remove M2 source from M0]
Available M2 values:
IR_InAll [IR In (ALL) input jack]
Generator [Internal IR encoder]
IR_Route IR_Out M0 Show Display the current IR source for an
IR Output jack (next to each HDMI
input).
M0 = 1~6 (supports multiple port
selection by using “+”.)
Note: Commands will not be executed unless followed by a carriage return.
Commands are not case-sensitive.
To Next Page
Loading...