CYP XA-4 - Page 53

53
COMMANDS
DESCRIPTION VARIABLES
$FACTORY

Execute a factory reset and reboot the
unit.
!
Stored Copy EDIDs and Ethernet settings will not be reset.
$FWVER?

Display the current firmware version.
$HDCP_IN_SW N1

Enable or disable HDCP support for the
unit’s HDMI input.
N1 = ON, OFF
!
Affects Analyser mode only.
$HDCP_IN_SW?

Display the current HDCP support
setting for the unit’s HDMI input.
$HDCP_IN_VER N1

Set the HDCP version to use on the
unit’s HDMI input.
Available values for N1:
V1.4 [HDCP v1.4 only]
V1.4+V2.2 [HDCP v1.4 & v2.2]
!
Affects Analyser mode only.
$HDCP_IN_VER?

Display the current HDCP version used
on the unit’s HDMI input.
$HDCP_OUT_SW N1

Enable or disable HDCP support on the
unit’s HDMI output.
N1 = ON, OFF
!
Affects Pattern mode only.
$HDCP_OUT_SW?

Display the HDMI output’s HDCP
status. A status of "Talk" means HDCP is
currently performing handshaking.