CYP XA-4 - Page 57

57
COMMANDS
DESCRIPTION VARIABLES
$PATTERN N1

Select the test pattern to output. N1 = 1 ~ 58
$PATTERN?

Display the current test pattern
selection.
$RX_DDC N1

Enable or disable the DDC bus for the
HDMI input (Rx).
N1 = ON, OFF
$RX_DDC?

Display the DDC bus state for the HDMI
input (Rx).
$RX_HOTPLUG N1

Set hot plug value for the HDMI input
(Rx).
Available values for N1:
OFF [Set hot plug low]
ON [Set hot plug high]
TOGGLE [Toggle low→high]
$RX_HOTPLUG?

Display the current hot plug state for
the HDMI input (Rx).
$RX_HOTPLUG_T N1

Set the hot plug time (in milliseconds)
for the HDMI input (Rx).
N1 = 50 ~ 500 [50ms increments]
$RX_HOTPLUG_T?

Display the current hot plug time (in
milliseconds) for the HDMI input (Rx).
$RX_PC_TOL N1

Set PC source clock detection tolerance
for the HDMI input (Rx).
N1 = 1 ~ 10 [1/1000 ~ 10/1000]
$RX_PC_TOL?

Display the PC source clock detection
tolerance for the HDMI input (Rx).