60
COMMANDS
DESCRIPTION VARIABLES
ASP_PLL [Audio-Sample packet PLL (locked or unlocked)]
CHS_CODE [Channel-status audio coding]
CHS_SR [Channel-status sampling rate in kHz]
CHS_SS [Channel-status sampling size]
CHS_TYPE [Channel-status application type (consumer or professional)]
HBR [High-Bit-Rate packet status]
AIF [Display packet-AIF data in 2-digit hex]
AVI [Display packet-AVI data]
DRMI [Display packet-DMI data]
GCP [Display packet-GCP data]
SPD [Display packet-SPD data]
VSI [Display packet-VSI data]
SCDC_SCR_ENABLE [Rx SCDC source enable scrambling state]
SCDC_SCR_STATUS [SCDC sink scrambling status]
SCDC_SINK_VER [SCDC sink version]
SCDC_SOURCE_VER [SCDC source version]
$TASK_MODE N1
Set the unit’s operation mode to Signal
Analyser or Pattern Generation.
Available values for N1:
ANALYSER [Analyser Mode]
PATTERN [Pattern Mode]
$TASK_MODE?
Display the unit’s current operation
mode.
$TIMING N1
Select the output resolution timing to
use.
Available values for N1:
1 ~ 91 [All available standard
output resolutions]
92 [Bypass (Analyser mode
only)]
$TIMING?
Display the unit’s current output
resolution timing by timing number.
$TIMINGX?
Display the unit’s current output
resolution timing by timing name.
To Next Page
Loading...