CYP XA-4 - Page 61

61
COMMANDS
DESCRIPTION VARIABLES
$TMDS_FORMAT N1

Set the TMDS output format. N1 = HDMI, DVI
$TMDS_FORMAT?

Display the current TMDS output
format.
$TMDS_SW N1

Enable or disable TMDS output. N1 = ON, OFF [Off disables
video output]
$TMDS_SW?

Display the current TMDS output
status.
$TX_5V N1

Set the unit’s output +5V pin state to
follow the TMDS output state or to
always be on.
Available values for N1:
FOLLOW [Only output 5V if
there is a live signal]
ON [Always output 5V]
$TX_5V?

Display the current output +5V pin
setting.
$UPDATE_FW

Update firmware from USB & reboot
the unit.
$UPDATE_IMG1080

Update the 1920×1080 image from
USB & reboot the unit.
$UPDATE_IMG480

Update the 640×480 image from USB &
reboot the unit.