3.7 Frequently Asked Questions and Answers When applying TK3
Question 1: Can the TK3 power on before starting the power supply for
UAV?
Answer: No, the UAV will not be able to take off. The correct procedure is to
start the UAV first and then power it on.
Question 2: Can a broken wire be handled by myself?
Answer: The damaged wire cannot be handled by yourself. It must be sent
back to the manufacturer for treatment.
Question 3: Which interfaces of the TK3 system support hot swap?
Answer: TK3 is a power supply equipment for high voltage. All interfaces do
not support hot plug. Remember!
Question 4: How to judge whether the tether is working normally by turning
on the power?
Answer: Turn on the “Power switch”, the normal output power of the
ground end display means that the tether is working normally.
71
To Next Page
Loading...