D-Link COVR-1900 - Static Route - Ipv6

78D-Link COVR-1900 User Manual
Section 3 - Configuration
Static Route - IPv6
In the Features menu on the bar at the top of the page, click Static Route to access the IPv4 Static Route settings, then click
IPv6 to configure the IPv6 Static Routes.
To configure the Static Route IPv4 settings, click the IPv4 link. Refer to Static Route - IPv4 on page 77
Click Save at any time to save the changes you have made on this page.
If you wish to remove a route, click on the trash can icon in the Delete column. If you wish
to edit a route, click on the pencil icon in the Edit column. If you wish to create a new route,
click the Add Route button.
If you clicked on
Edit or Add Rule, the following options will appear:
Name Enter a name for the rule.
DestNetwork This is the IP address of the router used to reach the specified
destina
tion.
PrefixLen Enter the IPv6 address prefix length of the packets that will
take this route.
Gateway Enter your next hop gateway to be taken when this route is
used.
Metric Enter a route metric value ranging from 0 to 15. This value
indicates the cost of using this route.
Interface Select the interface that the IP packet must use to transit out
of the router when this route is used.