DAP-400P Quick Installation Guide
Access Point or Repeater
In order to connect your device to a wired router for adding a wireless network
to the existing local network, on the Device mode page, from the
Connection method list, select the Autonomous value. Then from the
Work mode list, select the Access point value. In this mode you can
change the LAN IP address, set your own settings for the wireless network in
the 2.4GHz and 5GHz bands, and set your own password for access to the
web-based interface of the device.
In order to connect your device to a wireless router for extending the range of
the existing wireless network, on the Device mode page, from the
Connection method list, select the Autonomous value. Then from the
Work mode list, select the Repeater value. In this mode you can change the
LAN IP address, connect your device to another access point, set your own
settings for the wireless network in the 2.4GHz and 5GHz bands, and set your
own password for access to the web-based interface of the device.
23
To Next Page
Loading...
Need help?
General
