D-Link DCS-8000LHV2 User Manual

20D-Link DCS-8000LHV2 User Manual
Appendix B - Regulatory Statements
Federal Communication Commission Interference Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Non-modication Statement
Any changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
Caution
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance
with FCC multi-transmitter product procedures. For product available in the USA/Canada market, only channel 1~11 can be operated. Selection
of other channels is not possible.
Note
The country code selection is for non-USA models only and is not available to all USA models. Per FCC regulations, all WiFi product marketed in
the USA must be xed to USA operational channels only.
Regulatory Information

D-Link DCS-8000LHV2 Specifications

General

Sensor type	CMOS
Progressive scan	Yes
Number of sensors	-
Optical sensor size	1/2.7 \
Fixed focal length	3.28 mm
Maximum aperture number	2.2
LED type	IR
Night vision distance	5 m
Type	IP security camera
Certification	CE, LVD, FCC Class B, IC, RCM, NCC
Placement supported	Indoor
Connectivity technology	Wired & Wireless
Minimum illumination	0 lx
Audio formats supported	AAC, LC-AAC
Security algorithms	WPA, WPA2, WPA3
Alert notification type	Snapshot alert message, Text alert message
Total megapixels	- MP
Maximum resolution	1920 x 1080 pixels
Supported video modes	1080p
Video compression formats	H.264
Supported graphics resolutions	1920 x 1080 (HD 1080)
Ethernet LAN	No
Wi-Fi standards	802.11g, Wi-Fi 4 (802.11n)
Wi-Fi data rate (max)	2400 Mbit/s
Supported network protocols	IPv4, IPv6, DHCP, Bonjour (mDNS and DNS-SD), ONVIF Profile S, RTSP, RTCP, RTP/SRTP, HTTPS
Mobile operating systems supported	Android, iOS
AC input voltage	100 - 240 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (max)	4 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	20 - 80 %
Mounting type	Desk/Wall
Product color	White
LED indicators	Status
Number of cameras	1
Harmonized System (HS) code	85258900

Weight and Dimensions

Depth	37 mm
Width	43 mm
Height	95 mm
Weight	59 g
Cable length	1.5 m