D-Link DCS-820L

29D-Link DCS-820L User Manual
Section 7: Advanced Features
Advanced Features
Enabling Direct Connect
1
Press and hold the Direct Connect button on the bottom of the camera
for at least ve seconds. The Cloud LED will start blinking blue, indicating
the Direct Connect mode is enabled.
2
Connect your mobile device to the myBabyCam-xxxx Wi-Fi network. (XXXX
is a 4-digit code, the last 4 digits of your camera’s MAC address.) Use the
Wi-Fi password you created during the Setup Wizard installation process.
During the initial steps with the Setup Wizard, you congured the camera to connect to your home Wi-Fi network. If you want to take your camera
with you, it's not a problem with the DCS-820L.* You can connect directly to your camera, which means there is no need for an Internet connection
or a router. Follow the steps below to enable Direct Connect.
Note: Once you are connected to the camera, you will no longer have Internet
access.
*You have the option of using a portable USB battery pack (not included) that supplies 5V/2A of power when you take the camera with you. Plug
the USB battery pack into the Micro-USB power port. The Power LED on the bottom of the camera will turn red when the camera is powered on.
Direct Connect