Use a 6 mm drill bit to drill two 26 mm deep holes over the pencil marks. Hammer in the plastic wall anchors to
support the screws.
Align the mount over the holes that are in the wall. Use the supplied screws to attach the mount to the surface of the
wall.
Mounting
Note: For Person Detection optimization, it is recommended to place the camera on a table.
FAQ
What do I do if my device is not working properly? Reset the device and reinstall it. To reset your device, use a paper
clip to press and hold the recessed Reset button until the LED turns solid red. During installation, ensure that:
your router is connected to the Internet and has Wi-Fi enabled
your mobile device is connected to your router Wi-Fi and has Bluetooth enabled
your mydlink device is in range of your Wi-Fi network
To Next Page
Loading...
