8
Configuring Your Camera with the
Setup Wizard
Click the Wizard
button to begin.
Your camera’s IP Address will be
displayed here.
To run the Setup Wizard, click on
Start->Programs->DCS-950 Series
Setup Wizard.
By default, the Admin ID and
Password are “admin” (lower case).
Enter this in both fields. To change
the Admin Password, select the
Change box and enter a New
Password.
The IP Address, Subnet Mask, and
Gateway of your camera must
correspond with your network settings
for you to access the camera. If you
are unsure of what these settings
should be, please check with your
network administrator.
Click Next.
Click Next.
To Next Page
Loading...
Need help?
General