D-Link DCS-5300G

Check Your Package Contents
These are the items included with your purchase:
If any of the below items are missing, please contact your reseller.
Before You Begin
You must have at least the following:
• Windows 98/Me/2000/XP
• A CD-ROM drive
• An available Ethernet connection
DCS-5300G
This product can be set up
using Internet Explorer 6.x
or above
Wireless Internet Camera
with Pan and Tilt
©2004 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of
their respective holders. Software and specifications subject to change without notice. DCS-5300G.07292004
DCS-5300G Internet Camera with Remote Control
A/V Cable
12V AC Power Adapter
CAT5 Ethernet Cable
CD-ROM with Manual and Installation Wizard
Camera Stand
Using a power supply
with a different voltage
rating will damage this
product and void the warranty.
2 Antennas

D-Link DCS-5300G Specifications

General

Model	DCS-5300G
Category	IP Camera
Resolution	640 x 480
Pan/Tilt	Yes
Wireless	Yes
Power Supply	5V DC, 2.5A
Sensor	1/4\" CMOS
Lens	F2.0
Network Interface	Ethernet 10/100 Mbps
Wireless Protocol	802.11g
Compression	MJPEG
Protocols	TCP/IP, HTTP, SMTP, FTP, DHCP, DNS, DDNS, UPnP, PPPoE, NTP
Security	WEP
Audio Support	Two-way audio

Summary

Before You Begin

System Requirements

Details the minimum requirements for operating the camera, including OS, CPU, memory, and browser versions.

Check Your Package Contents

Hardware Installation

Connect the Ethernet Cable

Connects the camera to the network via an Ethernet cable to its back panel connector.

Attach the External Power Supply

Connects the camera to a power source using the DC 12V power input and an AC outlet.

Connect to TV

Attaches the A/V cable to the camera's output and the TV's audio/video inputs.

Installing the Installation Wizard

Start Software Installation

Initiates the installation process by clicking 'Install Software' or 'Installation Wizard' from the CD.

Complete Wizard Steps

Follows on-screen prompts, clicking 'Next' to proceed and 'Finish' to conclude the installation.

Configuring Your Camera

Launch Configuration Tool

Starts the Installation Wizard by double-clicking the desktop icon to search for cameras.

Camera Detection and Selection

Allows the wizard to detect cameras and select the DCS-5300G by checking a box.

Set Administrative Password

Enters and confirms an administrative password for root access to the camera.

Configure Network Settings

Unchecks 'Reset IP address at next boot' and applies network configuration settings.

Finalize Configuration

Clicks 'Done' after settings are saved, then 'Link to Selected Device(s)' to complete.

Viewing Your Internet Camera

Technical Support