2
Hardware Installation
System Requirements
• Internet Explorer 6.x or above
• CPU: 1.7GHz or above
• Memory Size: 128MB (256MB recommended)
• VGA card resolution: 800x600 or above
Note: If using multiple cameras for viewing/recording, the minimum requirements
are a 2.4GHz or above CPU with 512MB memory and a 32MB video card.
Connect the Ethernet Cable
Connect an Ethernet cable to the Ethernet connector located
on the Internet Camera’s back panel and attach it to the
network.
Attach the External Power Supply
Attach the external power supply to the DC power input
connector located on the Internet Camera’s back panel
(labeled DC 12V) and connect it to an AC power outlet.
Both the red and green LEDs will flash alternately and only the red LED will remain lit.
The green LED will not come on until you have configured your camera.
If you connect this camera directly to a PC,
you will need a cross-over Ethernet cable. If
you plug the camera into a hub or router, you
will be able to use the cable included with your camera.
Power source is confirmed when
the LED Power Indicator on the
Internet Camera is illuminated.
To Next Page
Loading...
Need help?
General