10BASE-T Stackable Hubs
3. With the cursor on the OK selection, press Enter. The main menu
screen will be displayed.
NOTE: When the hub is shipped from the factory, the
default user name is SNMP-T and the default
password is also SNMP-T. You will need to
use this user name and password when you
first set up your hub or if you have completely
reset the hub settings using the
Factory
Reset NVRAM to Default Value
menu
selection. Be sure to change this user name
and password (as described below) to
protect the security of your hub.
There are two levels of user privileges: Super User and General User. The
default user (SNMP-T) has Super User privileges. Some menu selections
available to users with Super User privileges may not be available to General
Users. The main menu shown below is the menu for users with Super User
privileges:
Figure 6 -2 Main Menu
6-4 Using the Console Interface
To Next Page
Loading...
