10BASE-T Stackable Hubs
Describes how to stack master and slave hubs into
an integrated hub stack.
♦ Chapter 5. Network Connections
Describes how to connect workstations to the hub,
and the hub to other hubs and network components
on a local area network.
♦ Chapter 6. Using the Console Interface
Describes how to configure the hub and a
manageable stack using the console program.
♦ Appendix A. Product Specifications
Provides information on the physical and electrical
specifications of the hubs.
♦ Appendix B. Power-On Self Test
Provides information about the POST messages
used for troubleshooting problems with the hub.
♦ Appendix C. Boot Configuration File
Describes the hub boot configuration file.
♦ Appendix D. Cables and Connectors
Describes the specifications of the cables and
connectors used with the hubs.
Table of Contents vii
To Next Page
Loading...
