10BASE-T Stackable Hubs
contact information for the person responsible for administering the hub.
The string can be up to 64 characters long.
♦ syslocation string
Takes string as the System Location, corresponding to the SNMP MIB II
variable
sysLocation. This field is used to indicate the physical
location of the hub for administrative purposes. The string can be up to
64 characters long.
♦
baud-rate n
Sets the console port transmission rate used when the port is being used
in out-of-band mode. Legal values for the parameter n are: 1200, 2400,
9600, and 19200.
♦
snmpt-image string
Takes string (which may be up to 64 characters long) as the filename on
the TFTP server of the image file to be used. When the hub boots, it will
load the given image file from the server and execute it. This command
may be used to update the hub’s software when a new version is available
from SNMP.
♦
ip-netmask mask
Uses mask as the network mask for the local network. The mask should
be in the form xxx.xxx.xxx.xxx, where each xxx is a number between 0 and
255. For a class C network with no subnetting, the netmask should be
255.255.255.0.
♦
ip-default address
Uses address as the hub’s IP address. The address should be in the form
xxx.xxx.xxx.xxx, where each xxx is a number between 0 and 255.
♦
auth-trap enable/disable
C-2 Boot Configuration File
To Next Page
Loading...
