D-Link DES-1228/ME - Page 110

DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
106
The Multiple Spanning Tree Protocol commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table:
enable stp
disable stp
config stp version [mstp | rstp | stp]
config stp {maxage <value 6-40> | maxhops <value 6-40> | hellotime <value 1-2> | forwarddelay
<value 4-30>| txholdcount <value 1-10> | fbpdu [enable | disable] } (1)
config stp ports <portlist> {externalCost [auto | <value 1-200000000>] | hellotime <value 1-2> | migrate [yes
| no] |edge [true | false | auto] | restricted_role [true | false] | restricted_tcn [true | false] | p2p
[true | false | auto] |state [enable | disable] | fbpdu [enable | disable]} (1)
create stp instance_id <value 1-8>
config stp instance _id <value 1-8> [add_vlan | remove_vlan] <vidlist>
delete stp instance_id <value 1-8>
config stp priority <value 0-61440> instance_id <value 0-8>
config stp
mst_config_id
{revision_level <int 0-65535> | name <string>} (1)
config stp mst_ports <portlist> instance_id <value 0-8> {internalCost [auto |<value 1-200000000>] | priority
<value 0-240>} (1)
show stp
show stp ports {<portlist>} {instance <value 0-8>}
show stp instance {<value 0-8>}
show stp mst_config id
config stp trap {new_root [enable |disable] | topo_change [enable |disable]} (1)
Each command is listed, in detail, in the following sections: