D-Link DFL-260E

6
ENGLISH
7
To establish a console connection:
1. Plug the female end of the supplied RJ-45-
to-DB9 cable directly to the console port on
the Firewall, and tighten the captive retaining
screws.
2. Connect the other end of the cable to
a terminal or to the serial connector of
a computer running terminal emulation
software. Use the following settings for
terminal emulation software:
Baud rate: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
3. Once you have correctly set up the terminal,
switch on your device. A boot sequence will
appear on the terminal screen.
4. Once the boot sequence completes, the
command prompt is displayed, the device is
ready to be congured.
After initial setup, please refer to the companion
publications found in PDF format on the accom-
panying master CD for detailed instructions on
conguring the DFL-260E/860E.
D-Link NetDefend Firewall User Manual
This document describes the general operation
and control of the NetDefendOS rmware,
D-Link’s proprietary operating system that drives
and controls the NetDefend rewall.
The User Manual includes detailed instructions
regarding typical administrative tasks.
D-Link NetDefend Firewall Log Reference
Guide
This document describes all log messages that
might be generated by the NetDefendOS.
D-Link NetDefend Firewall CLI Reference
Guide
This document describes all available text-
based commands that can be used with the
RJ-45-to-DB9 Console or SSH interface to
congure the rewall.
Finalizing the Conguration
In addition to the user manual, the Master
CD also includes many device conguration
examples. Additional help is available through
D-Link worldwide ofces listed in the appendix
of the User Manual or online. To learn more
about D-Link security product products, please
visit the website http://security.dlink.com.tw. For
support, please visit the website http://support.
dlink.com.tw, which will redirect you to your
regional D-Link website.
Additional Information
TECHNICAL SUPPORT
United Kingdom (Mon-Fri) website: http://
www.dlink.co.uk FTP: ftp://ftp.dlink.co.uk
Home Wireless/Broadband 0871 873 3000
(9.00am–06.00pm, Sat 10.00am-02.00pm)
Managed, Smart, & Wireless Switches, or
Firewalls 0871 873 0909 (09.00am- 05.30pm)
(BT 10ppm, other carriers may vary.)
Ireland (Mon-Fri)
All Products 1890 886 899 (09.00am-06.00pm,
Sat 10.00am-02.00pm)
Phone rates: €0.05ppm peak, €0.045ppm off
peak times