Information in this document is subject to change without notice. Reproduction in any manner whatsoever,
without the written permission of D-Link Corporation, is strictly forbidden.
Trademarks used in this text: D-Link and the D-LINK logo are trademarks of D-Link Corporation; Microsoft and
Windows are registered trademarks of Microsoft Corporation.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the
marks and names or their products. D-Link Corporation disclaims any proprietary interest in trademarks and trade
names other than its own.
© 2018 D-Link Corporation. All rights reserved.
January 2018, P/N 651GS1510095G
FCC Warning
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with this manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference in which case the user will
be required to correct the interference at his expense.
CE Mark Warning
This equipment is compliant with Class A of CISPR 32. In a residential environment, this equipment
may cause radio interference.
VCCI Warning
この装置は、クラス A 情報技術装置です。この装置を家庭環境で使用すると電波妨害を引き起こすこ
とがあります。この場合には使用者が適切な対策を講ずるよう要求されることがあります。
VCCI-A
BSMI Notice
此為甲類資訊技術設備，於居住環境中使用時，可能會造成射頻擾動，在此種情況下，使用者會被要求
採取某些適當的對策。
Safety Compliance
Warning: Class 1 Laser Product:
• EN: When using a fiber optic media expansion module, never look at the transmit laser while it
is powered on. Also, never look directly at the fiber TX port and fiber cable ends when they are
powered on.
• FR: Ne regardez jamais le laser tant qu’il est sous tension. Ne regardez jamais directement le
port TX (Tramsmission) à fibres optiques et les embouts de câbles à fibres optiques tant qu’ils
sont sous tension.
To Next Page
Loading...
