DGS-3024 Layer 2 Switch CLI Reference Manual
To enable RMON:
DGS-3024:4#enable rmon
Command: enable rmon
Success.
DGS-3024:4#
disable rmon
Purpose Used to disable RMON on the Switch.
Syntax
disable rmon
Description
This command is used, in conjunction with the enable rmon
command above, to enable and disable remote monitoring (RMON)
on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To disable RMON:
DGS-3024:4#disable rmon
Command: disable rmon
Success.
DGS-3024:4#
create trusted_host
Purpose Used to create the trusted host.
Syntax
create trusted_host <ipaddr>
Description
The create trusted_host command creates the trusted host. The
Switch allows you to specify up to four IP addresses that are allowed
to manage the Switch via in-band SNMP or TELNET based
management software. These IP addresses must be members of the
Management VLAN. If no IP addresses are specified, then there is
nothing to prevent any IP address from accessing the Switch,
provided the user knows the Username and Password.
Parameters
<ipaddr> − The IP address of the trusted host to be created.
Restrictions Only administrator-level users can issue this command.
Example usage:
To create the trusted host:
41
To Next Page
Loading...
