DGS-3024 Gigabit Ethernet Switch Manual
Using SNMPv3 individual users or groups of SNMP managers can be allowed to perform or be restricted from performing
specific SNMP management functions. The functions allowed or restricted are defined using the Object Identifier (OID)
associated with a specific MIB. An additional layer of security is available for SNMPv3 in that SNMP messages may be
encrypted. To read more about how to configure SNMPv3 settings for the Switch read the next section.
SNMP User Table
Use the SNMP User Table window to create a new SNMP user and add the user to an existing SNMP group or to a newly
created group.
Figure 9- 4. SNMP User Table window
To delete an existing entry, click the Delete icon in the right-hand column that corresponds to the port you want to remove.
To create a new entry, click the Add button, a separate window will appear.
Figure 9- 5. SNMP User Table Configuration window
The following parameters can be set:
Parameter Description
User Name
Enter an alphanumeric string of up to 32 characters. This is used to identify the SNMP
user.
Group Name
This name is used to specify the SNMP group created can request SNMP messages.
SNMP V3 Encryption
Check to use encryption.
Auth-Protocol
MD5 - Specifies that the HMAC-MD5-96 authentication level will be used. This field is
only operable when the Encryption field has been checked. This field will require the
user to enter a password.
108
To Next Page
Loading...
