D-Link DGS-3024 - Port Configuration

DGS-3024 Gigabit Ethernet Switch Manual
Port Configuration
Figure 7- 4. Port Configuration window
To configure Switch ports:
1. Choose the port or sequential range of ports using the From and To pull-down menus.
2. Use the remaining pull-down menus to configure the parameters described below:
Parameter Description
State <Enabled>
Toggle the State field to either enable or disable a given port or group of ports.
Speed/Duplex <Auto>
Toggle the Speed/Duplex field to either select the speed and duplex/half-duplex
state of the port. Auto denotes auto-negotiation between 10 and 100 Mbps
devices, in full- or half-duplex. The Auto setting allows the port to automatically
determine the fastest settin
g
s the device the
p
ort is connected to can handle, and
26