DGS-3024 Gigabit Ethernet Switch Manual
TxPeriod
This sets the TxPeriod of time for the authenticator PAE state machine. This value
determines the period of an EAP Request/Identity packet transmitted to the client. The
default setting is 30 seconds.
QuietPeriod
This allows you to set the number of seconds that the Switch remains in the quiet state
following a failed authentication exchange with the client. The default setting is 60
seconds.
SuppTimeout
This value determines timeout conditions in the exchanges between the Authenticator
and the client. The default setting is 30 seconds.
ServerTimeout
This value determines timeout conditions in the exchanges between the Authenticator
and the authentication server. The default setting is 30 seconds.
MaxReq
The maximum number of times that the Switch will retransmit an EAP Request to the
client before it times out of the authentication sessions. The default setting is 2.
ReAuthPeriod
A constant that defines a nonzero number of seconds between periodic
reauthentication of the client. The default setting is 3600 seconds.
ReAuth
Determines whether regular reauthentication will take place on this port. The default
setting is Disabled.
Click Apply to implement your configuration changes. To view configurations for the 802.1x Authenticator Settings, click
Show Authenticators Setting
.
Local users
Figure 7- 56. 802.1x Local User Table Configuration window
Enter a User Name, Password, and confirmation of that password. Properly configured local users will be displayed in the
802.1x Local User Table in the same window.
802.1x Capability Settings
Click 802.1x Capability Settings to view the following window:
80
To Next Page
Loading...
