9D-Link DHP-307AV User Manual
Section 2 - Installation
5. Adding More Adapters
If you would like to add more than two adapters, press the button of the additional adapter for no more than two seconds. The Power LED will start
blinking after you release the button. Then press the button of any adapter in your existing Powerline network for no more than two seconds. The
Power LED will start blinking after you release the button.
Note: Both Security buttons must be pressed within two minutes. After above network security setup steps, your Powerline network will be securely
congured with the same network encryption key.
To Next Page
Loading...
