D-Link DHP-W310 - Firmware Upgrade

25D-Link DHP-W310AV User Manual
Section 3 - Conguration
Firmware
You can upgrade the rmware of the DHP-W310AV from this page. Make sure the rmware you would like to use is on the local hard drive of
your computer. Click Browse... to locate the rmware le to be used for the update. Please check the D-Link support site for rmware updates at
http://support.dlink.com. You can download rmware upgrades to your hard drive from the D-Link support site.
Click on the blue hyperlink at the top of the
page the to nd out if there is an updated
rmware or language pack. If a new version
exists, download the new rmware to your
hard drive.
After you have downloaded the new rmware,
click Browse... to locate the rmware update on
your hard drive. Click Upload to complete the
rmware upgrade.
You can change the interface language of the
device by uploading a language pack. To install
a language pack, click the Browse... button
to locate the D-Link language pack upgrade
le on your computer. Once you have found
the le, click the Upload button to begin the
language pack upgrade process. This can take
a minute or more. Finally, wait for the device to
reboot. This process can take about 75 seconds.
Firmware
Information:
Firmware Upgrade:
Language Pack
Upgrade: