6
Chapter 3 Network Settings
The default IP address of the DI-704 is 192.168.0.1, and the default subnet mask is
255.255.255.0. These addresses can be changed to meet your need, but the default values are
used in this manual. If the TCP/IP environment of your computer has not yet been
configured, you can refer to Appendix B to configure it. For example,
1. configure IP as 192.168.0.2, subnet mask as 255.255.255.0 and gateway as
192.168.0.1, or,
2. configure your computers to load TCP/IP settings automatically, via the DHCP
server built into the DI-704.
After installing the TCP/IP communication protocol, you can use the ping command to
check if your computer has successfully connected to the DI-704. The following example
shows the ping procedure for Windows 95 platforms. First, execute the ping command
ping 192.168.0.1
If the following messages appear:
Pinging 192.168.0.1 with 32 bytes of data:
Reply from 192.168.0.1: bytes=32 time=2ms TTL=64
A communication link between your computer and the DI-704 has been successfully
established. Otherwise, if you get the following messages,
Pinging 192.168.0.1 with 32 bytes of data:
Request timed out.
there must be something wrong with the installation. Follow the steps again to make sure the
network settings are correct. You should check the following items in sequence:
To Next Page
Loading...
Need help?
General
